JavaScript is disabled. Because that a much better experience, please permit JavaScript in your browser prior to proceeding.

You are watching: How to replace upper control arm bushings chevrolet s10


*

Before I obtain a "do a search" rant, every post I discovered was around lowered or lifted trucks. My truck is stock, and also I desire to save it the way.Okay, It"s the bushings on the driver"s side, appropriate by the dang steering arm. I"ve been told two things:1. The the bushings deserve to be replaced without removing the arm or the shaft. Simply remove the nuts and also washers, air-chisel the bushings out, slide the new bushings over the shaft and align them come the manage arm, location the washer and nut behind the brand-new bushing, and run them up with a wrench and also they will certainly seat into the control arm.or... 2. The the control arm needs to be removed, and the bushings have to be pressed in.So i m sorry is correct, or is there another way?
1995 regular cab S-10 2WD4.3 TBI, 5 speed, 360,000 + miles!
*

I can"t imagine how or why friend would desire to do this through the arm still in the truck. Take it out, wait chisel or cut the bushings out, push in the brand-new ones, then reassemble.
*

I can"t imagine just how or why you would want to carry out this through the eight still in the truck. Take it it out, wait chisel or reduced the bushings out, press in the new ones, climate reassemble.
1995 regular cab S-10 2WD4.3 TBI, 5 speed, 360,000 + miles!
The bushings are press in/press out. If friend dont very own a press, take it to NAPA...They will do it for cheap.
Yes, they can be done without completely removing the upper regulate arm,Advanced Auto rents a push kit come remove and also install the bushings the you deserve to barely squeeze out in there.My advice would be to eliminate the whole regulate arm, you will have to loosen the two tower nuts anyways to fit the push clamp, might as well pull that out.

See more: 60 Over On 350 Bored 60 Over Cubic Inches With A 350 Block, 60 Over On 350 Block


Removal that UCA1. Progressive the former of the vehicle, assistance the lower regulate arm v floor stands.2. Remove the tire and wheel assembly.Remove the wheel rate sensor harness and the brake hose bracket native the upper manage arm.5. Remove the retaining bolts and also nuts native the upper regulate arm. Keep in mind the ar of any shims.Remove the upper regulate arm.Inspect all of the components for wear and also damage.removal the bushings3. Remove the upper regulate arm bushings. (air hammer, punch, press, however)4. Eliminate the upper regulate arm tower from the upper control arm.5. Install the upper manage arm obelisk to the upper control arm. Install the regulate arm bushings to the upper regulate arm (where you need a press)6. Tighten J 22269-1 until the bushing is positioned on the shaft and the upper regulate arm together shown. The measurement need to be 12.8 - 13.8 mm (0.48 - 0.52 inch)
top top both ends.